Description
1987 Caterham 7 W/ de Deon rear suspension. Front suspension Has been upgraded to double wishbone. Front and rear shocks Koni’s series 2812 W/ Eibch springs. Engine Dry Sump 1700 BDC W/ Lucas Mark IV fuel injection 235hp at 8500 red lines at 9800. I just pulled the engine an replaced the valve seals and checked all brg. and pistons. Has a new timing belt. Ignition, Mallory HyFire Transmission is the single rail type W/ integral bell housing and Straight cut racing gears. Clutch is twin disc W/ center hydraulic release new disks when engine was out. Super Starter and new ring gear. Differential, limited slip with 4.6 ratio Wheels are Magnesium 14X7 Gages, Autometer oil filed Set is carbon fiber On a 2.1 klm course 6 curves with two 170 deg. hairpins and a 400 meter back straight 1 was turning it in 1min.3sec I weigh 200 lb.
Recent Competition History
7 trophies, 1998 3rd place in points
Performance Data
Class: one make race
Weight: 1400 lbs
Track: Sukuba, Japan 2.1klm
Engine
Engine Builder: Cosworth
Manufacturer: Cosworth
Type: BD
Displacement: 1700 cc
Horsepower: 235
Induction: Lucas Mark IV fuel injection
Heads: Cosworth
Block: Ford 711M
Crankshaft: Cosworth
Connecting Rods: Cosworth
Pistons: Cosworth
Camshaft: Cosworth F1 inlet F1 ex.
Valves: Cosworth
Clutch: Tilton twin disc
Pressure Plate: Cosworth
Flywheel: Cosworth
Exhaust: Cosworth
Races: 12
Fuel System
Fuel Cell
Manufacturer: Fuel Safe
Age: new
Capacity: 17 gal
Fuel Pump: elct and macnical
Fuel Type: AV gas
Oil/Water System
Radiator: aluminum
Water Rad Location: front
Water Pump: high volume
Oil Cooler: aluminum
Oil Cooler Location: front
Electrical System
Ignition: Mallory Hy Fire
Battery: Race drycell new
Data Logger: unipro laptimer
Transmission
Manfacturer: Ford
Type: 4 speed single rail
Gears: Stright cut racing
Races: 12
Rear End
Manufacturer: Ford
Type: LS
Ratio: 4.6
Case: aluminum
Races: 12
Chassis
Type: Spaceframe
Builder: Arch Motors
Material: steel
Finish: Poder coting and paint
Condition: very good
Front Suspension: double wish bone, powder coating very good
