Description:

This Reynard is in perfect condition with a 3 litre Mugen producing 470 Bhp. The car runs a
'92 spec "H" pattern gearbox. The standard '93 fitment was a sequential 'box and the driver preferred
being able to shift down, skipping gears. It is accompanied
by enough spares to almost assemble a second car. The spares are listed below. The car features a full
Astratech data logging system and is race ready.


History

Originally to Tom's Toyota, then run by Apache in the British F2 series where it nearly won
the championship, finishing 2nd after being let down by a mechanical DNF in the final race. The car
ran a DFY up to this point, and was then fitted with the Mugen.
Engine

• Mugen V8
  
• 3 litre
  
• 470 Bhp
  
• approximately 1/3 through life cycle
  
• carbon clutch
  

Oil/Water System

• sidepod rads
  

Electrical System

• Full Astratech data logging system
  

Body

• carbon
  

Chassis

• carbon
  
• tbd
  
• dual wishbone, pushrod
  
• pushrod
  
• rack
  
  

Spares

• 1 complete gearbox
  
• 1 tub
  
• 2 nose boxes
  
• 1 front wrng
  
• 3 rh front end plates
  
• 3 lh front end plates
  
• 1 rh front flap
  
• 1 lh front flap
  
• 1 rear main plane with pillars
  
• 1 engine cover
  
• 2 rh side pods
  
• 1 lh slde pod
  
• 1 rh radiator air duct
  
• 1 lh radiator air duct
  
• 1 fuel tank
  
• 2 nose covers
  
• 3 front floors
  
• 2 rear floors
  
• 4 wheel nuts
  
• 1 DFY installation kit (4 engine pick up points, studs, bottom, mounting plate)
  
• 1 front lh bottom wishbone
  
• 1 front rh bottom wishbone
  
• 1 front rh top wishbone
  
• 1 front pushrod
  
• 2 front track rods
  
• 2 rear top wishbones
  
• 1 rear bottom wishbone lh
  
• 2 rear pushrods with strain gauges
  
• 4 rear track rods
  
• 1 radiator
  
• 1 drive shaft
  
• 17 suspension pickup points (various)
  
• 4 big hubs for uprights (one hub complete with bearing mount and bearings)
  
• 10 wlre stays for nose
  
• 4 floor steel stays
  
• 3 disc bells
  
• 1 front mono bar
  
• 1 front bridge bar
  
• 1 dfy exhaust
  
• dfy water alloy pipes
  
• 8 rear wheels (big hub}
  
• 6 front wheels (big hub)
  
• 1 gearbox oil pump
  
• 2 front rockers
  
• 4 upright bearings
  
• 3 upright seals
  
• 2 dfy flywheels
  
• 3 cv covers
  
• 4 diff bearings
  
• 1 engine shaft
  
• 1 diff cv hub
  
• 2 diff rumps
  
• 3 diff discs
  
• 4 selector forks for gear box
  
• 2 selector fingers
  
• 1 reverse gear
  
• 1 battery mount
  
• 9 brake air ducts
  
• 10 set suspension springs
  
• 1 brake disc
  
• 1 alloy mount for master cylinders and front bottom wishbone
  
• 250 (approx) gear ratios (too many to count exactly)