Description:

2009 E92 M3 Race Car

This car was originally a street car and converted to race with SCCA in Northern California. Mileage is approximately 110,000. This car has been meticulously maintained with lots of upgrades and sleek features. While I intended to race this car in the GT2 class of SCCA, I was only able to run a few events with the car after it was fully built due to unforeseen life circumstances. Please see below for the list of modifications done to the car and I have tried to be as thorough as possible. Car comes with many small extras not listed as well.

Car is located at Sonoma Raceway, CA. 

Car weighs a little less than 3,100lbs and has been corner balanced for a 200lb driver

I have more photos upon request but please only reach out if you are a serious buyer

•Chasis
o TC designs 8 point SCCA/NASA spec roll cage
o RS Futures quick detach front splitter
o RS Futures rear wing
o Lexan windows
o AJ Hartman Front Winglets
o Trackspec Hood Vents

•Suspension
o All suspension arms are billet Turner Motorsport arms and have been adjusted to correct for new roll center with exception of rear upper camber arms which are SPL 
o Dampers are JRZ RS Pro 2-way adjustable front and rear with external reservoirs
o Front springs are 2.25 ID 900lbs
o Rear springs are 2.25 ID 1200lbs
o Ground Control Race top hats with camber and caster adjustment
o Polyurethan Subframe Bushing
o Aluminum Diff bushings
o Upgraded sway bars front and rear
o Polyurethane sway bar bushings
o Adjustable Sway bar endlinks

•Drivetrain
o 4.10 rear differential
o Solid mounted aluminum RTD Shifter
o Solid aluminum motor and transmission mounts
o Bimmerworld baffled, aluminum power steering fluid reservoir with new lines
o OMP Alcantara Steering wheel with quick detach and 60mm spacer
o

•Technology
o AIM MXG dash and datalogger
o Car is wired for a radio with push to talk on steering wheel

•Saftey and comfort
o Fire suppression system in cockpit and engine bay
o Recaro SPG Hans drivers seat and Pole position passenger seat on custom floor mounted brackets
o Coolshirt sytem
o Master Kill Switch
o Bimmerworld Aluminum Pedals
o Allstar performance window net
o Schroth 6 Point Harness for both driver and passenger

•Engine
o All CSF Coolers
o Bimmerworld oil diverter valve
o Gates Performance thermostat
o Bimmerworld wet sump baffle kit
o MachSchnell Intake and filter
o Akropovic titanium Catless down/midpipe section
o BPM tune
o BE Rod bearings with ARP Studs
o Aluminum ECS coolant bleeder screw

•Brakes and Wheels
o Stoptech Trophy Kit with Hawk DTC 70 and DTC 60 Pads (front and rear respectively) and new Stoptech rotors
o Braided stainless brake lines on all corners
o Hard Motorsport brake backing plates for rotor cooling
o Apex ARC 8 18x10.5 inch square set up (car comes with a full extra backup set) 

•Other
o Hard Motorsports trunk panel delete
o Throttle actuators recently replaced
o New fuel pressure regulator
o Ac and blower motor delete

Website:

Keyword Search Terms: